Wyeforce Harbor Tug

Here are a couple of photos of the running gear. The manual says that you don't need to make any holes to install oiling tubes in the propshaft, personally I prefer to do so plus I did not like the plastic bushing ends on the original propshafts so I purchase two Graupner 8mm replacements which have brass bushing at each end I also purchase two greasing nipples to be inserted over the propshaft when I have made the holes. The Graupner Propshafts ar slightly longer but I do not see this being any problem.

Here are a couple of photos of the running gear. As mentioned in the Wyeforce main page I plan to do some additional detailing on this kit so I have made the two cooling boxes that will be installed either side of the hull.